8 x 1250 W multi-channel installation DSP amplifier

• 8 x 1250 W multi-channel installation DSP amplifier with digitally controlled PFC supply


• Fully integrated DSP with high-resolution 96 kHz processing and FIR Drive


• Dante and OCA integration via OMNEO with fallback options


• Parallel, bridged and parallel-bridged drive modes with 70/100V and low impedance operation


• High efficiency Eco Rail technology for lower operating costs
  

IPX Series

Multi-Channel Power Amplifiers for Fixed Install Applications

High Power Density — up to 20 kW

• IPX series amplifiers represent the perfect mix of seemingly unlimited power with cutting edge intelligent FIR-drive DSP to give you the power and the ultimate performance for any demanding sound system requirements in permanent installations. Engineered and made in Germany, the IPX series power amplifiers comprise of three 4-channel models and one 8-channel model, offering a power density of 5 kW, 10 kW and even 20 kW from a single amplifier with all channels driven.

  
  

Equipped with Dante and OCA

• As installers increasingly utilize existing networks in building infrastructure, relying on IP technology often results in faster system integrations and lower implementation costs — including reduced cabling — for substantial cost savings.

  The integrated OMNEO interface with a primary and secondary port allows the flawless use of 8 channels from a Dante audio network, while remote and supervision parameters run on OCA protocol (AES70), open for third-party integration. Redundancy options include glitch-free and RSTP to suit individual requirements and existing infrastructure.

  
  

Most Sophisticated Digital Signal Processing

• The IPX series offers advanced 96 kHz high-resolution digital signal processing for the highest performance, internal analog-to-digital conversion with ultra-low latency, and a superior signal-to-noise ratio. The three DSP blocks are split into user-, array- and speaker processing controls, each featuring a wide range of EQ-, delay and level options to match a wide range of applications. Complete remote control and supervision is available via the powerful IRIS-Net software and allows the IPX series to be seamlessly integrated into both existing and new installations.

  
  

Advanced Power Management

• The new Eco Rail technology developed by Dynacord helps to reduce overall power consumption up to 50%, both protecting the environment and significantly lowering the total cost of ownership, while maintaining high-quality audio and operational safety at all times. The fully DSP-controlled amplifier and power supply constantly monitors up to 280 parameters simultaneously to assure that even under challenging operating conditions such as mains power fluctuations, the IPX series continues to perform at highest possible level, rather than switching into a protect mode and stop operation.

  
  

High Installation Flexibility

• IPX series offers high flexibility for a variety of installation scenarios. This is ensured by several power drive options utilizing Dynacord’s patented VLD (Variable Load Drive) technology as well as the newly developed parallel and parallel-bridged operation modes. VLD technology allows the available output power of e.g. 1,250 watts per channel to be used at either 4 or 8 Ohms, or via 70V or 100V lines in direct drive mode.

  
  

IPX series multi-channel power amplifiers mark the new, unprecedented standard for sound system amplification in mid to large-sized permanent installations. Our new high-performance amplifiers offer seemingly unlimited power and pristine audio quality. IPX series multi-channel amplifiers are naturally equipped with both Dante and OCA, thanks to its OMNEO IP networking architecture. They embody several proprietary amplifier technologies developed by Dynacord engineering, one of the most experienced R&D teams in the audio industry.

IPX series can cover a wide range of demanding fixed installation venues, from concert halls, art centers, theatres, and houses of worship to distributed sound systems in stadiums and entertainment centers.

The new Eco Rail technology developed by Dynacord helps to reduce overall power consumption up to 50%, both protecting the environment and significantly lowering the total cost of ownership, while maintaining high-quality audio and operational safety at all times.